Canon BJC-800 Printer
General
Alternative Drivers 
Drivers you can use if the BJC-800 driver is not available. 
- DOS : BJ-200/200e/200ex (BJ Mode/Black)
 - DOS : Epson LQ2550 (LQ Mode Colour/Black)
  
Cartridges 
- BJI-643bk - Black Colour Ink Tank
 - BJI-643c - Cyan Colour Ink Tank
 - BJI-643m - Magenta Colour Ink Tank
 - BJI-643y - Yellow Colour Ink Tank
  
Serial Number 
Location - Back of the machine near power inlet Prefixes -  TYN... 
Special Paper 
- LC-101A4 - Coated A4 Paper.   Coated paper used for high quality print.
 - LC-101A3 - Coated A3 Paper.   Coated paper used for high quality print.
  
Error Codes
| Error Code | Error Condition | Solution |  
| 10 CHECK PAPER | Paper Pickup Error / No Paper | Add Paper or clear paper jam and press ONLINE |  
| 12 COVER OPEN | Cover is open | Close the cover |  
| 13 CHECK PAPER | Paper Jam or Exit Paper Jam | Clear paper jam and press ONLINE |  
| 14 NO INK CART. | Ink cartridge(s) not installed | Install cartridges |  
| 16 NO BLACK INK | Require Black ink | Install new ink cartridge |  
| 16 NO YELLOW INK | Requires Yellow ink | Install new ink cartridge |  
| 16 NO MAGENTA INK | Requires Magenta ink | Install new ink cartridge |  
| 40 SERVICE | SCSI interface error | Requires Service |  
| 50 Service | Carriage errors | Requires Service |  
| 51 Service | Capping error | Requires Service |  
| 52 | Printhead | Requires Service |  
| 53 | Printhead | Requires Service |  
| 54 | Printhead | Requires Service |  
| 55 | Printhead | Requires Service |  
| 56 | Printhead | Requires Service |  
| 57 | Printhead | Requires Service |  
| 58 | Printhead | Requires Service |  
| 59 | Printhead | Requires Service |  
| 5A,5B,5C,5D SERVICE | Ink detection errors | Requires Service |  
| 5E / 5F SERVICE | Carriage Motor errors | See Notes Below. If problem Persists, then the printer  requires a service |  
| 61,62,63,65,66,68,72 SERVICE | Internal hardware errors | Requires Service |  
| 65 Service  1 Beep | Engine Rom checksum error | Requires Service |  
| 65 Service  2 Beeps | Engine Ram checksum error | Requires Service |  
| 65 Service  3 Beeps | Printer Controller Error 2 Error | Requires Service |  
| 65 Service  4 Beeps | Printer Controller Error 2 Error | Requires Service |  
| 65 Service  5 Beeps | Flexible Cable Check Error 1 | Requires Service |  
| 65 Service  6 Beeps | Flexible Cable Check Error 2 | Requires Service |  
| 65 Service  7 Beeps | No Operator display | Requires Service |  
| 65 Service  8 Beeps | Controller Error | Requires Service |  
 
Notes - Error 5E is indicated 
- Turn the printer off
 - Open the top cover and check to see if the carriage lock lever is set correctly.
 - This lever is used to lock the carriage when the printer is to be transported.
  
Menu Flow Chart
| Level 1 | Level 2 | Level 3 |  
| Printing Mode | Mode-A * (Coated or Plain paper) Mode-B (Transparency) Mode-C (Mode A with BOLD black) Mode-D Mode-E (Draft mode) |   |  
| Cleaning | Cleaning-A Cleaning-B |   |  
| Set Parameter | Color | K,C,M,Y,R,G,B |  
|   | Chr. Spacing | 10,12,15 Proportional. |  
|   | Condensed Mode | On, Off |  
|   | Page Length | 11 inch, 12 inch |  
|   | Line Length (Paper Width) | 8 inch, 11 inch |  
|   | Select Font | Roman Sans Serif Courier |  
|   | Character Table | Graphics * Italics Courier |  
|   | International (Code Page) | USA * France Germany England Denmark Sweden Italy Spain Norway Korea Legal |  
|   | Auto LF (line Feed) | OFF *, ON |  
|   | DC1/DC3 | Enable * Disable |  
|   | CR Code | Not Print * Print |  
| Test Print | Test Print-A Nozzle Check |   |  
| Dump Mode | Dump OFF * Dump ON (prints downloaded hex data) |   |  
| Interface Select | Parallel * |   |  
|   | SCSI | ID# = n |  
| Country Code | English *, French etc (Display language) |   |  
| NVRAM Initialize | INIT NO * INIT YES (resets printer to factory defaults) |   |  
| Media Select | Normal Paper * Envelope/Thick |   |  
 
Factory Default value = * 
To enter the Menu 
- Press ONLINE (to set printer OFFLINE)
 - Press MENU
 - Press < or > to select LEVEL 1 settings, press ENTER
 - Press < or > to select LEVEL 2 choices, press ENTER
 - Press < or > to select LEVEL 3 choices if applicable and press ENTER
 - Press EXIT
 - Press ONLINE
  
 
 
 
 
 |