 Acer File Extensions |
Canon BJC-85 Printer
Error Codes
| Power | Error | Beeps | Error Condition | Solution |
|---|---|---|---|---|
| Off | Off | No Power | ||
| On | Off | Ready | ||
| On | On | 1 | Paper Pickup Error or out of paper | Add Paper or clear paper jam and press the RESUME button |
| On | Blinks | 2 | Low Ink Warning | |
| On | On | 2 | Paper Jam | Clear paper jam and press the RESUME button |
| On | On | 3 | BJ Cartridge Check | Insure a Printhead is installed or check installation of the printhead |
| On | Blinks | 4 | Low Battery Warning | Recharge the NiCAD battery |
| On | On | 4 | Cartridge Mismatch | Wrong type of cartidge is installed, ie IS scanner cartidge installed at time of printing |
| On | Blinks | 5 | Waste Ink Warning | Press RESUME to continue, though the printer will require a service. |
| Blinks | Blinks | Long + Short | Low Battery Error | Recharge the NiCAD battery if this fails replace the NiCAD |
| Blinks | Blinks | 1, 2 | ROM / RAM or EEPROM fault | Try unplugging the printer for 20 seconds, if this doesn't work then requires service |
| Blinks | Blinks | 3 | Cartridge out of position | Try reinstalling or replacing the cartridge, if this fails then it requires service |
| Blinks | Blinks | 4 | Carriage home postion error | Requires service |
| Blinks | Blinks | 5 | Waste Ink Full | Requires service |
| Blinks | Blinks | 6 | Temperature Error | Try replacing the Printhead, if this fails then the printer requires service |
| Blinks | Blinks | 7 | Print position | Requires service |
| Blinks | Blinks | 8 | Temperature Error | Try replacing the Printhead, if this fails then the printer requires service |
| Blinks | Blinks | 9 | Diode error (printhead) | Try replacing the Printhead, if this fails then the printer requires service |
| Blinks | Blinks | 10 | Cleaning Fault | Requires service |
| Blinks | Blinks | 11 | EEPROM | Try unplugging the printer for 20 seconds, if this doesn't work then requires service |
Waste Error Reset
1: Unplug Power Cord
2: Hold POWER and RESUME buttons
3: Plug in Power Cord
4: Release buttons after the printers starts up
5: Hold CARTRIDGE and RESUME
6: Press POWER
7: Release all buttons after the beeps
8: Press CARTRIDGE 16 times
9: Press RESUME
10: Unplug the Power cord