
Packard Bell Mercure M/Board

Specification
- Audio : SigmaTel STAC9721 Codec
- BIOS : AMI
- Chipset : Intel 815 chipset consisting of the 82815 Graphics and AGP Memory Controller Hub (GMCH) and the 82801AB I/O Controller Hub (ICH2).
- CPU Support :Socket 370
- Supports Intel Celeron FC-PGA (Flip-Chip Pin Grid Array) processor 533/66 to 700/66 MHz and faster.
- Supports Intel PIII Coppermine FC-PGA (Flip-Chip Pin Grid Array) - 600/100 to 850/100 MHz and faster, 600/133 to 900/133 MHz and faster
- Warning: Not all the above processors have been qualified. Check their current status with the Hardware Engineering dpt.
- 66/100/133 MHz Host bus speed processors are supported.
- Form Factor : ATX 24.4 x 21.0 cm Form Factor
- RAM :
- Supports 3 memory banks using two 168-pin unbuffered DIMM.
- Supports up to 3 double sided DIMMS at a clock speed of 100 MHz.
- Supports up to 2 double sided or 3 single sided DIMMS at a clock speed of 133 MHz.
- Supports a maximum memory size of 512 MB (128-bit technology) or 256 MB (64-bit technology) for SDRAM.
- Supports 3.3 V SDRAM DIMMs with gold-plated contacts.
- ECC memory checking is not supported
- Video : Integrated in chipset
Adding RAM is the most cost effective way to boost your computer's performance.
Jumpers
| Jumper | Configuration |
| JP18 - Clear CMOS Jumper (CMOS) | 2-3: Normal operation (default) 1-2: Clear current BIOS default settings |
| JP15 - Safe Mode/Recovery/Normal jumper | 1-2: Normal (default) 2-3: Safe Mode (Restores safe values / loads the BIOS setup on boot) Open: Recovery (used only to flash a corrupted BIOS) |
| JP4 - Suspend To RAM (STR) | Open: Disable STR mode Close: Enable STR mode |
| JP3 - PS/2 Keyboard Power On | 1-2: Enabled (default) 2-3: Disabled |
| JP1 - Rear USB Device Wake Up Selection | 1-2: Enabled (default) 2-3: Disabled |
| JP24 - CNR Selection | 1-2: CNR Secondary (Default) 2-3: CNR Primary AC'97 (onboard CODEC) disabled |
| JP31 - Front USB Keyboard Wake up | 1-2: Enabled (default) 2-3: Disabled |
|